Daylight polymer printing
82 × 49 x 74 cm
33 × 20 x 29 in
(W) x (D) x (H)
66 Kg (145 Lbs)
100–240 V, UK/USA/EU plug
23.8″ (3840×2160 px)
USB, Display Port
Resin Fill system
470 x 240 x 340 mm
18.5 x 9.4 x 13.4 in
50, 100 microns
0.002, 0.004 inches
XY pixel density
Cure speed at 100 micron
50-100 sec/layer (depending on resin)
Rachet Socket Wrench
Paper Strainer x 10
Nitrile Gloves x 4
Vat Film Pack sub-assembly
Gasket pack sub-assembly
5 Kg Pro Hard Black resin
2 VAT film replacement
Display Port Cable
Perpetual License for use with 2 pc’s. Compatible with Windows.
Minimum Computer Requirements:
– Operating System Windows 7, 8 or 10
– Minimum 2.0 Ghz processor speed 2 cores. Recommended 4 cores
– GPU capable of opening OpenGL version 3.0 or higher
– NET framework version 4.0
– 64bit system: recommended 4GB
– 32bit system: recommended 2GB
Spare DisplayPort connection
Note: In order to run at max resolution a 4K video card is required.
1 year Warranty
Extended warranty: 1 additional year – £350
The Liquid Crystal Pro vat body is fabricated from thermally welded 12mm Polypropylene: a tough plastic that is resistant to damage from cleaning chemicals. The top film frame is also Polypropylene. The bottom film frame is 4mm stainless steel and contributes further to the overall strength of the assembled vat. It won’t corrode when exposed to resin, water or cleaning chemicals. The skin of the vat is 100 micron FEP film, providing a flexible, non-stick surface to ensure good release of the printed part from the screen.
The Liquid Crystal Pro print platform is made from 5mm Aluminium tooling plate, bolted to a strengthening frame of 10mm tooling plate. This material is machined to ensure flatness, then cut to shape using a water-jet cutter, avoiding the potential for heat distortion caused by laser cutting. The L brackets are also Aluminium so there are no concerns about corrosion due to contact with resin, water or cleaning chemicals. The print plate is perforated to allow resin flow, ensuring consistent performance in the early layers of each print.
This pack contains five sheets of 100 micron FEP film, cut to the correct size for your Liquid Crystal Pro vat. We recommend that you re-skin your vat after 400 hours of printing, or if any visible damage is detected. 100 micron FEP film provides a flexible, non-stick surface to ensure good release of the printed part from the screen. It is thick and tough enough to last for days of printing time. Also included in this pack are five vat top gaskets and five vat bottom gaskets.
Ideal for those who need more than one computer running the software. Also for customers when your 1 year license expires.
Creative Workshop is a Slicer and host controller application for your SLA printer. It works on Windows only. It allows you to load and hollow models, generate supports, slice, & control your printer
Licence Number will be sent to you after purchase.